Disassembly
Removing and Replacing the Endo Housing
20
1.
Remove the rear housing cover, battery, and antenna as described in the
procedures.
®
2.
Using a Torx
driver with a T-6 bit, remove the six screws from the rear endo
housing as shown in Figure 8A.
3.
Set the screws aside for reuse.
4.
Carefully separate the front endo from the rear endo.
Figure 8. Removing and Replacing the Endo Housing
5.
To replace, align the front endo screw hole posts to the rear endo screw holes.
6.
Insert and torque the six screws to 2.6 in. pounds.
7.
Replace the antenna, battery, and rear housing cover as described in the
procedures.
July 19, 2002
020446o
6881040B85