Preparations And Connections; Installing Batteries In The Remote Control; Remote Control Operation Range; Setting The Video Output Format Selector (Tv Mode) Switch - Yamaha GX-505VCD Owner's Manual

Preparations and connections

Installing batteries in the remote control

1
3
2

Remote control operation range

DISC 1 DISC 2 DISC 3
3–DISC VCD CHANGER
STANDBY
STANDBY
/ON TIMER
INPUT PRESET/TUNING/BAND A/B/C/D/E
/
MINI COMPONENT SYSTEM GX–505VCD
DIRECTION
AUTO REVERSE CASSETTE DECK DOLBY B NR

Setting the video output format selector (TV MODE) switch

TV MODE
PAL
AUTO
NTSC
ANTENNA
FM GND AM
75 UNBAL.
FREQUENCY STEP DIGITAL OUT
50 K H Z 9 K H Z OPTICAL
FM AM
100 K H Z 10 K H Z
TV MODE
PAL
AUTO
NTSC
SUBWOOFER VIDEO SIGNAL
OUT
MONITOR
OUT
DISC CHANGE OPEN/CLOSE
VIDEO CD
DIGITAL VIDEO
Version 2.0 / Playback Control
YMERSION B.BOOST MUSIC
VOLUME
UP
DOWN
KARAOKE
MIC MIXING
1 MIC 2
OPEN/CLOSE
MIN MAX
VOLTAGE
SELECTOR
1
Turn the remote control over and remove the battery
compartment cover by sliding it in the direction of the
2
Insert the batteries (AA, R6, UM-3 type) according to the
polarity markings on the inside of the battery compartment.
3
Attach the battery compartment cover.
Notes
• Be sure the polarities are correct. (see the illustration inside the battery
compartment.)
• Remove the batteries if the remote control is not used for an extended
period of time.
• If batteries leak, dispose of them immediately. Avoid touching the leaked
material or letting it come in contact with clothing, etc. Clean the battery
compartment thoroughly before installing new batteries.
• Be sure to use the same type of batteries.
• Do not use a new battery and an old battery together.
Notes
• The area between the remote control and the main unit must be clear of
large obstacles.
• Do not expose the remote control sensor to strong lighting, in particular,
an inverter type fluorescent lamp. Otherwise, the remote control may not
work properly. If necessary, position the main unit away from direct
lighting.
Battery replacement
If you find that the remote control must be used closer to the main
unit, the batteries are weak. Replace both batteries with new ones.
This system is designed for use with the NTSC and PAL television
formats. Set this switch to the position of the format your TV
monitor employs.
PAL: Set to this position if your TV monitor employs the PAL
format.
AUTO: Set to this position if your TV monitor can be switched in
between the PAL and NTSC formats automatically
(originally set to this mode).
NTSC: Set to this position if your TV monitor employs the
NTSC format.
mark.
-5
E