Learning A New Function - Yamaha DSP-A1 Owner's Manual

LEARNING A NEW FUNCTION

1
Place this remote control transmitter and the other
remote control transmitter so that they face each other.
This remote control
transmitter
2
CLEAR
(Press by using the point of
a mechanical pencil, etc.)
* If there is no operation for about 30 seconds after the
LEARN button is pressed, the TRANSMIT/LEARN indicator
flashes rapidly and the current mode is canceled. If this
occurs, repeat this step.
3
If necessary, select the memory area by using the A/B/C
switch on the side panel of the remote control
transmitter.
4
Press the key on this remote control transmitter in which
you will store a new function.
Lights up.
* If a key which cannot learn another function is pressed, the
TRANSMIT/LEARN indicator flashes rapidly and the current
mode is canceled. If this occurs, repeat this step.
* If there is no operation for about 30 seconds after a key is
pressed, the TRANSMIT/LEARN indicator flashes rapidly
and the mode before you began learning operations is
restored. If this occurs, restart from step 2.
70
Other remote
control transmitter
About 5–10 cm
(2–4 in.)
TRANSMIT
/LEARN
LEARN MACRO
Flashes slowly.
5
Press and hold the key (on the other remote control
transmitter) which has the function you want to store.
When learning is finished, the TRANSMIT/LEARN indicator
stops lighting. You can release the key. Then the indicator
begins flashing slowly.
* If a signal is not successfully received, the
TRANSMIT/LEARN indicator flashes rapidly and the mode
prior to step 4 is restored. If this occurs, restart from step 4.
* If memory capacity is full, the TRANSMIT/LEARN indicator
flashes rapidly to show you that learning is impossible, and
then the mode before you began learning operations is
restored.
6
Repeat step 3–5 to store more functions.
7
When you finish the learning operation, press the
LEARN button.
CLEAR
Notes
Newly learned functions will replace previously learned
functions.
If there is no more room in the memory area for a function to
be learned, the TRANSMIT/LEARN indicator will flash
rapidly. In this case, even if some keys are not occupied
with functions from other remote control transmitters, no
further learning is possible.
If you close the lid while learning, and then about 5 seconds
pass, the TRANSMIT/LEARN indicator flashes rapidly and
the mode before beginning learning operations is restored. If
this occurs, restart from step 2. However, if you open the lid
within 5 seconds, the mode before closing the lid is
restored.
There may occasionally be instances in which, due to the
signal-coding and modulation employed by the other remote
control transmitter, this remote control transmitter will not be
able to "learn" its signals.
When you press the LEARN, MACRO or CLEAR button, or
the RESET button inside of the battery compartment by
using a sharp-pointed thing, be careful not to damage the
button. If you will use a mechanical pencil, make sure that
the lead is not coming out.
LEARN MACRO