Programming A New Remote Control Function (Learn Feature) - Yamaha DSP-AZ1 Owner's Manual

REMOTE CONTROL FEATURES

Programming a new remote control function (Learn feature)

If you want to program functions not included in the basic operations covered by the manufacturer code, or a manufacturer code is not
available, the following procedure needs to be performed. The possible programming area is the same as a component control area, so the
buttons are programmable independently for each source component area.
TRANSMIT RE–NAME CLEAR
SYSTEM
POWER STANDBY
CABLE SAT
D–TV/LD VCR 1
SOURCE
DISPLAY
SELECT
SEARCH
POWER REC
10KEY DSP HALL 1
1
1
ROCK
CONCERT
1
1
Set 10KEY/DSP to 10KEY.
10KEY
Caution
• It is also possible to program in the control area of this unit
with 10KEY/DSP set to DSP. However, if you program
functions in this area, you cannot control this unit and select a
DSP program.
2
2
Press an input selector button to select a source
component.
3
3
Place this remote control and the other remote
control about 5 to 10 cm apart on a flat surface so
that their infrared transmitters are aimed at each
other.
5 to 10 cm (2 to 4 inch)
4
4 Press LEARN by using a ballpoint pen or similar
object.
"LEARN" and the selected component name appear alternately
in the display window.
LEARN
E-
68
4, 8
MACRO
LEARN MACRO OFF ON
V–AUX TUNER PHONO
2
MD/TAPE CD–R CD
VCR 2 VCR3/DVR DVD
6CH INPUT
TITLE
ENTER
MENU SOUND
CHAPTER
STOP PAUSE PLAY
HALL 2 CHURCH JAZZ CLUB
2 3 4
ENTER– CONCERT CONCERT
TA NMENT V DEO 1 V DEO 2
DSP
LEARN
DVD
Cautions
• If you do not press any button within 30 seconds during steps
5 and 6, the learning process is canceled. If this happens, start
over from step 4.
• Do not press and hold LEARN longer than 3 seconds.
Otherwise this unit enters the manufacturer code setting
mode.
5
5 Press the button for which you want to program the
new function.
"LEARN" is displayed.
6
6 Press and hold the button on the other remote
control that has the function you want to program
into this remote control until "OK" appears in the
display window.
Cautions
• "NG" appears in the display window when programming has
not been done correctly. In this case, start over from step 5.
• When the memory is full, "FULL" appears in the display
window, and this remote control cannot acquire any more
functions. Clear unnecessary programmed functions to allow
the unit to acquire new functions.
7
7
Repeat steps 5 and 6 to program additional func-
tions.
8
8
Press LEARN again to exit from the learning mode.
LEARN
Cautions
• Learning may not be possible in the following cases:
1 when the batteries in the remote control for this unit or other
component are weak
2 when the distance between the two remote controls is too
much or too little
3 when the remote control infrared windows are not facing with
appropriate angle
4 when the remote control is exposed to the direct sunlight
5 when the function to be programmed is continuous or
uncommon
• "ERROR" appears in the display window in the following
circumstances:
1 when pressing more than one button at once
2 when MACRO ON/OFF is switched to another position