To Activate The Cw Identifier - Vertex Standard VX-150 Operating Manual

ARTS
(Automatic Range Transponder System)
Press the [ F ] key, then press the [ F/W ] key again, to begin entry of the letters and
numbers in your callsign.
Rotate the DIAL to select the first letter or number in your callsign. When the correct
character has been selected, press the [ ] key to move on to the next character.
Repeat step
"slant bar" (– • • – • ) is among the available characters, should you be a "portable"
station.
When you have entered your entire callsign, press the [ F/W ] key.
Press the PTT key to save the settings and exit to normal operation.
Note that the "DE" (– • • • ) preceding your callsign is already programmed; you only need
to program your callsign, and the "DE" will be appended at the time of transmission.

To activate the CW identifier:

Press the [ F ] key, then press the [ 0 ( SET ) ] key, to enter the Set mode.
Rotate the DIAL to select Menu #29 ("
Press the [ F ] key to enable changing of this Menu item.
Rotate the DIAL to set the CW ID function ON.
When you have made your selection, press the PTT key to save the new setting and exit
to normal operation.
VX-150 O
PERATING
as many times as necessary to complete your callsign. Note that the
M
ANUAL
").
Operation
29