Yaesu FT-8900R Operating Manual page 67

Menu #34 [ SCAN ]
Function: Selects the Scan-Resume mode.
Available Values: TIME/BUSY
Default: BUSY
TIME: The scanner will halt on a signal it encounters, and will hold five seconds. If you do
not take action to disable the scanner within five seconds, the scanner will resume
even if the stations are still active.
BUSY: The scanner will halt on a signal it encounters. Two seconds after the carrier has
dropped because the other station(s) ceased transmission, the scanner will resume.
Note: This Menu Item can be set independently for each band.
Menu #35 [ SCAN M ]
Function: Selects the Memory Scan mode
Available Values: MEM/MSM
Default: MEM
MEM: Enables Memory Scanning on all memory channels (except the memory channel skip
memory).
MSM: Enables Memory Scanning on Preferential Memory Channels only.
Menu #36 [ SHIFT ]
Function: Sets the magnitude of the Repeater Shift.
Available Values: 0.00 - 99.95 MHz (50 kHz step)
Default: Depends on the band of operation.
Note: This Menu Item can be set independently for each band.
Menu #37 [ STEP ]
Function: Sets the Synthesizer steps.
Available Values: 5.0 k/10.0 k/12.5 k/15.0 k/20.0 k/25.0 k/50.0 k
Default: Depends on the band of operation.
Note: This Menu Item can be set independently for each band.
Menu #38 [ SPCONT ]
Function: Defines the audio path to the external speaker (when used).
Available Values: EXT/OFF/ INT.EXT/INT
Default: EXT
EXT: The audio is routed to external speaker (internal speaker is off).
OFF: The audio is not routed (internal and external speakers are both off).
INT.EXT: The audio is routed to both the internal and external speakers.
INT: The audio is routed to the internal speaker only (external speaker is off).
FT-8900R Operating Manual
M
ENU
S M
ET ODE
65