Yaesu FT-8900R Operating Manual page 63

Menu #7 [ CWID ]
Function: Enables/disables the CW identifier during ARTS operation.
Available Values: TX ON/TX OFF
Default: TX OFF
Menu #8 [ CWID W ]
Function: Stores your callsign into the CW identifier. Up to six characters may be stored.
See page 45 for details.
Menu #9 [ DIMMER ]
Function: Setting of the Display brightness level.
Available Values: DIM 1/DIM 2/DIM 3/OFF
Default: DIM 1
Menu #10 [ DCS.COD ]
Function: Setting the DCS code.
Available Values: 104 Standard DCS codes.
Default: 023
Menu #11 [ DCS.N/R ]
Function: Selects "Normal" or "inverted" DCS
coding.
Available Values: TRX N/RX R/TX R/TRX R
Default: TRX N
Menu #12 [ DSP.SUB ]
Function: Selects the Sub Band display format.
Available Values: FREQ/CWID/DC-IN/OFF
Default: FREQ
FREQ: Displays the "Sub" band frequency (Dual band operation).
CWID: Displays the CW ID.
DC-IN: Displays the DC supply voltage.
OFF: No Display.
Note: When this Menu Item is set to any selection other than the "FREQ" the "Sub" band
receiver will be disabled.
Menu #13 [ DTMF D ]
Function: Setting of the DTMF Autodialer Delay Time.
Available Values: 50MS/250MS/450MS/750MS/1000MS
Default: 450MS
FT-8900R Operating Manual
M
ENU
023 025 026 031 032 036 043 047 051 053
054 065 071 072 073 074 114 115 116 122
125 131 132 134 143 145 152 155 156 162
165 172 174 205 212 223 225 226 243 244
245 246 251 252 255 261 263 265 266 271
274 306 311 315 325 331 332 343 346 351
356 364 365 371 411 412 413 423 431 432
445 446 452 454 455 462 464 465 466 503
506 516 523 526 532 546 565 606 612 624
627 631 632 654 662 664 703 712 723 731
732 734 743 754
S M
ET
DCS CODE
– – – –
ODE
– –
61