Sony RM-M7G Service Manual page 12

Proceed as follows to control the video camera from this unit
after connection.
3 Press the PANEL ACTIVE button of this unit.
The PANEL ACTIVE lamp lights and you can contro!
the video camera by using this unit.
Now, you can monitor the adjusted items on the
monitor connected to the MONITOR OUT connector
of the CCU-M7 or the MONITOR connector of this
unit.
The lamps on the CCU-M7 also lights according to
the operation of this unit.
The PANEL ACTIVE button of this unit may not be
operative while adjusting the controls of the CCU-M7 even if
you press it. In this case, stop turning the controls, and
press the PANEL ACTIVE button again.
Turn on the CCU-M7 camera control unit and
video camera.
The video camera is controlled not from this unit but
the CCU-M7.
1. GENE DES
If necessary, make the following adjustments on
the CCU-M7:
¢ Selection of the format of the video output signal
from the CCU-M7 (Video output selector)
¢ Adjustment of the cable compensation level
(CABLE COMP FINE control screws)
e Adjustment of the subcarrier phase (GC PHASE
switch and adjustment screw)
¢ Adjustment of the horizontal phase (H PHASE
switch and adjustment screw)
To control the video camera from the CCU-M7
Press PANEL ACTIVE of the CCU-M7 so that its lamp lights.
The PANEL ACTIVE button of this unit goes off, and you can
control the video camera by using the CCU-M7.
RM-M7G (UC) 1-9