Related Manuals for King Industrial KC-780FX
Summary of Contents for King Industrial KC-780FX
- Page 1 6” X 48” BELT & 12” DISC SANDER MODEL: KC-780FX INSTRUCTION MANUAL COPYRIGHT © 2023 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.
-
Page 3: Warranty Information
WARRANTY INFORMATION 2-YEAR KING CANADA TOOLS LIMITED WARRANTY OFFERS A 2-YEAR LIMITED WARRANTY FOR THIS BELT AND DISC SANDER FOR NON-COMMERCIAL USE. PROOF OF PURCHASE Please keep your dated proof of purchase for warranty and servicing purposes. REPLACEMENT PARTS Replacement parts for this product are available at our authorized King Canada service centers across Canada. Please use the 10 digit part numbers listed in this manual for all part orders where applicable. - Page 4 SAFETY INSTRUCTIONS FOR YOUR BELT AND DISC SANDERS SAFETY INSTRUCTIONS FOR BELT AND DISC SANDERS • sanding belt narrower than 1 inches. Narrower belts uncover parts Safety is a combination of common sense, staying alert and knowing that could trap your fingers. how your belt disc sander works.
- Page 5 SAFETY INSTRUCTIONS FOR YOUR BELT AND DISC SANDERS USE THE RIGHT TOOL. Don’t force tool or attachment to do a job it was not designed to do. • Avoid awkward operations and hand positions where a sudden slip could cause fingers or hand to move into a sanding surface. Keep Any power sanders can throw foreign object into eyes.
-
Page 6: Electrical Information
ELECTRICAL INFORMATION WARNING ALL ELECTRICAL CONNECTIONS MUST BE DONE BY A QUALIFIED ELECTRICIAN. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY! ALL ADJUSTMENTS OR REPAIRS MUST BE DONE WITH THE MACHINE DISCONNECTED FROM THE POWER SOURCE. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY! POWER SUPPLY- persons or children can’t turn the switch to the On position. -
Page 7: Getting To Know Your Sander
14. Quick belt release lever. 15. Belt cast-iron table. 16. Lower belt guard with dust chute. 17. Belt table angle pointer and scale. 18. Cabinet stand. SPECIFICATIONS MODEL KC-780FX 6” x 48” Belt Belt lift 0° - 90° Belt speed 1,066 SFPM Disc 12”... - Page 8 ASSEMBLY Clean all rust protected surfaces with ordinary house hold type grease or spot remover. Do not use: gasoline, paint thinner, mineral spirits, etc. These may damage painted surfaces. Apply a coat of paste wax to the tables to prevent rust. Wipe all parts thoroughly with a clean dry cloth.
-
Page 9: Disc Table Alignment
ADJUSTMENTS & OPERATION ADJUSTING SANDING BELT IN HORIZONTAL POSITION 1. Loosen cap screw (A) Fig.7 with the included 6 mm hex. key. This cap screw secures the sanding belt assembly in the vertical or horizontal position. 2. Remove the sanding belt table. 3. -
Page 10: Replacing Sanding Belt
ADJUSTMENTS & OPERATION INSTALLING AND ADJUSTING MITER GAUGE The miter gauge shown in Fig.11 can be installed in both table slots of the sanding belt table and the sanding disc table. It should be used as often as possible to provide workpiece support during sanding operations. -
Page 11: Sanding Belt Tracking Adjustment
ADJUSTMENTS & OPERATION REPLACING SANDING BELT continued... Replacement sanding belts listed below are available as optional accessories, contact your nearest King Canada distributor for more information. Model Size Grit SB-648-K-60 6” x 48” SB-648-K-80 6” x 48” SB-648-K-100 6” x 48” SB-648-K-120 6”... -
Page 12: Maintenance
MAINTENANCE WARNING: For your own safely, turn switch "OFF" and remove plug from power source outlet before adjusting, maintaining, or lubricating your belt and disc sander. WARNING: To avoid electrocution or fire, any repair to electrical system should be done by qualified service technicians. Unit must be reassembled exactly to factory specifications.