Related Manuals for King Industrial KC-OVS-TL
Summary of Contents for King Industrial KC-OVS-TL
- Page 1 04/2019 instrUction ManUal MODEL: KC-OVS-TL COPYRIGHT © 2014 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.
-
Page 2: Warranty Information
WarrantY inForMation 2-Year king canada tools liMited WarrantY oFFers a 2-Year liMited WarrantY For tHis oscillating spindle sander intended For coMMercial Use prooF oF pUrcHase Please keep your dated proof of purchase for warranty and servicing purposes. replaceMent parts Replacement parts for this product are available at our authorized King Canada service centres across Canada. liMited tool WarrantY King Canada makes every effort to ensure that this product meets high quality and durability standards. - Page 3 general & speciFic saFetY rUles 1. knoW YoUr tool watch) because they could get caught in moving parts. Non-slip Read and understand the owners manual and labels affixed to the footwear is recommended. Wear protective hair covering to contain tool. Learn its application and limitations as well as its specific po- long hair.
- Page 4 14) 1/4” sanding sleeve 7) Table insert (installed) 15) 90º stop bolt 8) Tilting table 16) 2” dust hood spindle sander specifications MODEL KC-OVS-TL Oscillations per minute Oscillations stroke 15/16” Spindle drum diameter 1 1/2” - 2” Spindle diameter 1/4” - 1/2” - 5/8”...
-
Page 5: Electrical Information
electrical inForMation Warning! ALL ELECTRICAL CONNECTIONS MUST BE DONE BY A QUALIFIED ELECTRICIAN. FAILURE TO COMPLY MAY RESULT IN SE- RIOUS INJURY! ALL ADJUSTMENTS OR REPAIRS MUST BE DONE WITH THE MACHINE DISCONNECTED FROM THE POWER SOURCE. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY! poWer sUpplY properlY groUnded oUtlet Warning: YOUR SPINDLE SANDER MUST BE CONNECTED TO A... -
Page 6: Assembly And Operation
asseMblY & operation Warning! IF ANY PART IS MISSING OR DAMAGED, DO NOT PLUG THE SPIN- DLE SANDER IN UNTIL YOU HAVE REPLACED THE MISSING OR DAMAGED PART. For your safety, complete the assembly of the spindle sander before plugging it into the power supply. -
Page 7: Assembly And Adjustments
asseMblY & adJUstMents installing a sanding spindle or drUM 1. Make sure the spindle sander is disconnected from the power source. 2. Select the desired sanding spindle or sanding drum to install. 3. Clean the threaded shaft of the spindle or drum and the oscillating spindle open- ing before mounting. - Page 8 adJUstMents & operation setting tHe table sqUare WitH tHe sanding spindle/drUM The squareness between the table and sanding spindle/drum has been adjusted at the factory. However, after a long period of operation, the squareness may be- come inaccurate. To adjust table square with sanding spindle/drum; 1.
-
Page 9: Maintenance
Maintenance & troUblesHooting Warning! FOR YOUR OWN SAFETY, TURN THE SWITCH OFF AND REMOVE THE PLUG FROM THE POWER SOURCE BEFORE PER- FORMING MAINTENANCE, CLEANING OR LUBRICATION WORK ON THE SPINDLE SANDER. cleaning / lUbricating 1. Blow out dust accumulation and wood chips inside the motor, housing, and dust chute frequently. 2.