Osd Language Setup; Clock Set - Samsung DVD-R130 Instruction Manual

If you connected an external Audio System, turn on your
Audio System and select AUX, CD or DVD.
The OSD (On-Screen Display) displayed on the screen
may vary depending on conditions such as the disc type
and whether the disc has been inserted or not.
| 1. OSD Language Setup
After plugging in the recorder, the first time you press the
POWER button, the screen shown below appears.
Press the POWER button.
With the unit in Stop mode/No Disc mode, press the
MENU button.
Select Setup using the AT buttons, then press the
ENTER or _" button.
"1_]jI
Press a number button to select the language.
m If the language for the start@ screen is not set,
the settings may change whenever you turn the
NOTE power on or off. Therefore, make sure that you
select the language you want to use.
| 2. Clock Set
This menu is used to set the current time. You need to
set the time first to use timer recording.
You must have the antenna/cable connected to
set the Auto Clock. See pages 15_17 for
Antenna connections(Method 1, 2 and 3).
If you have the antenna connected via Method 1 or 3 on
pages 15,17, the DVD Recorder automatically sets the
clock by searching for a channel that carries a time
signal and sets your time zone and daylight saving(if
applicable).
Select Clock Set using the ,_T buttons, then press
the ENTER or _ button.
Clock Set menu will be displayed.
Select Auto Clock Set using the ,_ buttons, then
press the ENTER or _, button.
NOTE
The Menus are slightly different depending on
whether a disc is inserted or not. The menus
described on the next few pages are with no
disc in the unit.
The menus are not available during playback
or recording.
If you have the antenna connected via Method 2 on
page 16, you have to set the clock manually.
See "Manual Clock set" on pages 30.
English - 29