Table of Contents
Advertisement
Playing Back your Recordings
TV Playback or Viewing
Your Camcorder may be connected to a
Before you begin...
* Connect the Camcorder to a power source.
TV to play back tapes or to view what you
are recording.
I Set the POWER switch to VCR for
tape playback.
Or, set to CAMERA to view what your
Camcorder is recording.
TV with AUDIO/VIDEO IN Jacks.
Back of TV
Zien the TV ON and set it to LINE
INPUT.
Check your TV operating instructions.
Note:
If your TV has no VIDEO or AUDIO IN
jacks, select CH 3 or 4 on your TV to match
the CH 3/4 switch setting on the OPTIONAL
PV-RF16 RF Adaptor. Set the VCR/TV
To Audio In | J
Audio/Video
QU
>
2
O
O
Lo
©
=<
Q
=
O
3
3 Start playback or begin a recording.
If you have connected the
Camcorder to your TV using the
PV-RF16 RF Adaptor and want to
watch TV only:
Set the POWER switch to OFF on the
To Audio/
Video Out
RF Adaptor
Camcorder.
(optional)
VHF Antenna
Then, set the VCR/TV Selector on the RF
|
Adaptor to TV.
(PA)
300 ohm-75 ohm
Now, turn the TV ON and select a
CH 3/4 Switch
N
transformer
channel.
|
AY
(not supplied)
CIO
or F Connector
am
UHF Antenna
CATV System Installer
This reminder is provided to call the CATV
VCR/TV
Back
of TV
system installer's attention to Article 820-40
Selector
ack o
of the NEC in USA (and to the Canadian
i
Electrical Code in Canada) that provides
O
guidelines for proper grounding and, in
particular, specifies that the cable ground
shall be connected to the grounding system
of the building, as close to the point of cable
entry as practical.
(not supplied)
To VHF Antenna
Terminal
Advertisement
Table of Contents
