Table of Contents
Advertisement
34
en | Configuration
Audio input
Select which audio input you want to use. Available options are Line In or integrated
Microphone.
Input volume
The recorded sound level can be adjusted with Input Volume slider.
Line Out
Adjust the audio level with the slider(s). Adjust so that the indicator does not go into the
red zone.
Recording format
Select a format for audio recording. The default value is 48 kbps. You can select 80 kbps,
G.711 or L16 depending on the required audio quality or sampling rate.
AAC audio technology is licensed by Fraunhofer IIS.
(http://www.iis.fraunhofer.de/amm/)
AAC bit rate
Select the required AAC bit rate.
Send audio
Audio can be sent via the Send audio button if the unit supports audio. The button activates
the audio backchannel connection.
1.
2.
You must have a speaker or similar connected to the line out of the camera in order to send
the audio.
Click Set to apply the changes.
4.4.14
Pixel Counter
The number of horizontal and vertical pixels covered by the highlighted area is displayed
below the picture. With these values you can check whether the requirements for specific
functions, for example, identification tasks, are fulfilled.
1.
2.
3.
4.5
Recording
Images can be recorded to an appropriately configured iSCSI system or, for devices with an
SD slot, locally to an SD card.
SD cards are the ideal solution for shorter storage times and temporary recordings. They
can be used for local alarm recording or to improve the overall reliability of video recording.
For long-term authoritative images use an appropriately sized iSCSI system.
Two recording tracks are available (Recording 1 and Recording 2). The encoder streams and
profiles can be selected for each of these tracks for both standard and alarm recordings.
Ten recording profiles are available where these recording tracks can be defined differently.
These profiles are then used for building schedules.
2023-10 | V02 | F.01U.407.683
Click and hold the Send audio button to send an audio signal to the unit.
Release the button to stop sending audio.
Click Freeze to freeze the camera image if the object that you want to measure is
moving.
To reposition a zone, place the cursor over the zone, hold down the mouse button and
drag into position.
To change the shape of a zone, place the cursor over the edge of the zone, hold down
the mouse button and drag the edge of the zone to the required position.
User Manual
FLEXIDOME corner 7100i IR
Bosch Security Systems
Advertisement
Table of Contents
