What Happens At Power-Up; When The Printer Is Ready For Operation - Tektronix Phaser 540 User Manual

2
Getting Set Up

What happens at power-up

Both status indicators (power and error ) on the printer's front panel
light briefly, messages appear in the display panel (LCD), and the printer
goes through a series of self-tests. The printer takes approximately
5 minutes to warm up and complete the self-tests (depending on the
amount of memory installed).
Exit
9008-43
After the self-tests run successfully, the printer prints a startup page and, if
the printer's copy count is between five and eight pages, a registration page.
The startup page prints whenever you turn on or reset the printer.
If you want to turn off the startup page, you can use the front panel menu or
use a software utility file provided on the drivers and utilities diskettes
included with your printer. Refer to "Enabling and disabling the startup
page" on page A-5 and the Phaser 540 Drivers and Utilities Printing Reference
for details on using the utility file.

When the printer is ready for operation

When the power-up sequence is complete, the green indicator is on steady
(not blinking), the red indicator is out, and the front panel message reads
Ready.
2-25
User Manual