Xerox DocuColor 5252 Administration Manual page 74

To o l s M o d e
2 - 7 4
3
When a Paper Tray on the screen is selected, the default
selections for Paper Weight and Paper Type are automatically
selected. Touch the number of the Paper Tray from which the
paper is feeding.
The button for 221 - 280 g/m
4
If there is still too much paper curl after trying the tips in the Key
Point on the previous page, follow the remaining steps in this
procedure.
Key point: Paper Tray 3 accepts paper weights from 64 to 280
2
g/m . If you select Paper Tray 3, buttons for Uncoated and
Coated are displayed under the Coating heading.
You may select from any of the displayed paper weights; 64 to 220
2
g/m , and either coated or uncoated paper. Select the correct
paper type if other than Paper Type A. Refer to the tables shown
previously in this section for the default settings for various market
areas.
5
Touch the Close button to save your selections and return to the
Machine Defaults 2 screen. Exit the Tools Mode and run a few test
prints to determine if the curl was reduced to a satisfactory level.
If curl is still excessive, access the Tools Mode again and try
another Paper Type setting. If you are not successful in reducing
the curl, call your Xerox service representative.
6
Touch the Reset button on the Decurler Setup screen to return to
the settings established when you first accessed the screen.
D o c u C o l o r 5 2 5 2 S y s t e m A d m in is t r a t i o n G u i d e
2
displays only for Tray 3.