Scsi Device Error Codes - Xerox 8850 System Introduction

XES Synergix 8825/8830/8850/8855 & X2-TECH System Introduction

SCSI Device Error Codes

Displayed in the Controller Configuration error log of the PRINTER
CONFIGURATION Test Print, SCSI Device Error Codes are in the
"1ncckkaa" format. The meaning of the error codes follows
Code Meaning
is the SCSI ID of device (0-F)
n
is the SCSI Command being executed at time of error
cc
is the SCSI Sense Key returned by command
kk
is the SCSI Additional Sense Code returned by command
aa
The SCSI ID should be used to determine the device which caused the error.
The Controller firmware only supports an internal SCSI Hard Disk Drive
(typically SCSI ID = 0). During normal operation no SCSI Hard Disk Drive
errors should be logged. If errors are logged to the Controller Error Code Log
that indicate a problem with the SCSI Hard Disk Drive refer to the
"Description / Action" section of the following table to determine the
appropriate action.
56