Xerox 4110 Print Options page 14

Option and settings
(default setting is underlined)
Print Master
Printer's default/No/Yes
Print Size
Same as Document Size/Letter LEF/
Letter SEF/ A4 LEF/A4 SEF/A5 LEF/A5 SEF/
A3 SEF/B5 LEF/B5 SEF/Statement SEF/
Executive LEF/Executive SEF/8x10 LEF/
8x10 SEF/8.5x13/Legal SEF/11x17 SEF/
A4 Cover LEF/9x11 LEF/12x18/SR-A3 SEF/
13x19 SEF/Postcard SEF/ Envelope Choukei
(Size 3)/Return Postcard SEF/Legal 13.5
SEF/16-kai LEF/16-kai SEF/Statement LEF
Printer Screen Mode
Graphics/Photo/Text
Punch
Off/2 Hole Punch/ 3 Hole Punch/
4 Hole Punch
Punch Position
None/Left or Top/ Right or Bottom
Remove White PPT Background
Off/On
Save Fast Reprint
On/Off/RIP only
Scale
25-400%
100%
P O
RINT PTIONS
Description
When you create a Master page from an
application and set this option to Yes,
the Master file prints.
Select this option to verify or confirm
the Master page.
Specify the print size of the document.
If the document's size is different from
the selected print size, the document is
scaled and printed at the specified print
size.
Select a pre-defined halftone screen to
set the lines-per-inch of the raster used
during printing.
Specify to hole-punch a job.
Specify the binder hole location.
Select On when using PowerPoint to create
variable data in conjunction with FreeForm.
Specify whether to save raster data to disk
after a job is printed, so that the data can
be reprinted without reRIPping.
Specify a scaling override for a print job.
Requirements, constraints,
and information
Printer's default reflects the setting specified
in Fiery EXP4110 Setup.
This option is available only if Create Master
is enabled.
For more information, see Variable Data
Printing.
N : Applicable click charges occur when
OTE
you print the Master.
This option is also available from
Command WorkStation.
With this option set to On, all print option
settings remain with the saved raster data
each time the job is reprinted. To print the
job with new print option settings, you must
remove the raster data and reRIP the job.
This option is available only as an override
from the job management tools.
N :
The supported range is 25 to 400%.
OTE
N :
This option is not the same as
OTE
the Scale option available from the
printer driver.
14