Table of Contents
Advertisement
®@ Self-Diagnosis Function in Normal Operation
1) Under normal operation of Refrigerator, if you press "Quick freeze" and
"Vacation" button at the same time for 6sec., temperature setup display
will proceed On/Off blink of all for 2sec. at 0.5sec. interval.
If you press "Quick freeze" and "Vacation" button continuously at the
same time for about 8sec. including 2sec. of repetition of LED' s On/Off,
self-Diagnosis function is selected.
2) At this moment, it goes into self-Diagnosis function with "Ding-dong"
buzzer sound.
3) When Error occurs, it is restored to normal state regardless of defect
repairing after signal lasts for 30sec. ("Ding-dong" buzzer sound).
4) While it is operating self-Diagnosis function, it does not accept input of
button.
7-8) Load Condition Indicating Function
}
® In normal operation, if you press "Quick freeze" and "Vacation" button
at the same time for 6 sec., all setup display of freezer and Refrigerator
are turned on. If you hand off from the button at this moment, temperature
setup display of freezer and Refrigerator will proceed On/Off blink of all for
2sec. at 0.5sec. interval. While On/Off blink is processing, if you press the
temperature setup button, it goes into load condition indicating function
(with ding-dong buzzer sound).
@ Load condition indicating mode shows from which load Micom signal
outputs at present. However, it only shows that micom signal is outputted
and does not confirm whether load is actually operating or not. That is,
even if load is displayed as it is operating, load may not operate because
of actual defect of load or defect of relay on PCB. During A/S, you can
use this function by applying the main function.
® Time required to indicate is 30 sec.. After 30sec., it is automatically
restored to the setup state before its function.
@ Corresponding display indication about load condition is shown as in the
following table.
* Load Mode Check List
Advertisement
Table of Contents
