Table of Contents
Advertisement
KingKORG NEO Parameter Guide
f .
BPM DELAY
Effect
This effect produces delay sounds that are synchronized with the
KingKORG NEO's tempo or the MIDI tempo.
Depth . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .[000...127]
This adjusts the amount of delay sound. Turning the knob toward the right will
produce a deeper effect.
Time . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [1/32, 1/16, 1/8, 1/6, 3/16, 1/4, 3/8, 1/2]
This specifies the spacing of the delay repeats in terms of a note length
relative to the tempo.
Turning the knob toward the right will lengthen the spacing. For example at
1/4, the delay repeats will be spaced at quarter note intervals. At 1/8 they will
be spaced at eighth note intervals.
Time setting list
1/32
1/16
1/8
Time
Note
CC#114
0~9
10~27
28~45
Value
Min
BPM
TIP:
There is a limit to the BPM that this effect can follow. If the limit is exceeded, the popup
screen that appears when you turn the TIME knob will indicate "Over!", and the actual
delay time will automatically be converted to a half or a quarter of the length specified by
the knob.
TIP:
If you use the virtual patch function to modulate the time, the "Over!" indication might
not appear correctly.
Block diagram
1/6
3/16
1/4
3/8
46~63
64~81
82~99
100~117 118~127
20.6
23.2
31.0
46.4
5 .
Global effects
The global effect is placed just before the OUTPUT in the effect chain.
Global effect settings cannot be saved for each program.
EQ
EQ is an effect that lets you adjust the volume of the high- and
low-frequency ranges.
You can use it to improve the balance of the sound, or to adjust
the final output appropriately for the acoustics of your
performance space or the response of your audio system.
This is a shelving-type two-band parametric equalizer that allows
you to change the cutoff frequency.
1/2
HIGH . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [–15dB...0dB...+15dB]
61.9
LOW . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [–15dB...0dB...+15dB]
Adjusts the gain of each band.
Using the knob will change the volume in the region of the center frequency.
Turning the knob toward the right of center will boost that region, and turning it
toward the left will attenuate that region.
EQ High (High EQ Freq .) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .[1 .00kHz...20 .00kHz]
EQ Low (Low EQ Freq .) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [20...1000Hz]
Adjust the cutoff frequency of each band.
TIP:
You can adjust each cutoff frequency by holding down the SHIFT/EXIT button and turn-
ing the HIGH knob or LOW knob.
TIP:
The HIGH and LOW cutoff frequencies can be set in Global mode. They can also be
saved as global settings. →Writing the global settings
tings"
).
TIP:
These settings cannot be saved for each program.
- 28 -
Effects
(OM: p.21 "1. Saving global set-
Advertisement
Table of Contents
