Displays, Messages, And Alerts; Power-Up Sequence - Motorola iDEN i530 Field Service Manual

CHAPTER 3

DISPLAYS, MESSAGES, AND ALERTS

To conduct basic troubleshooting and maintenance of the i530 unit, you must become familiar
with the display screens, errors, messages, and alert tones associated with the unit.
3.3

Power-Up Sequence

Extend the antenna for optimum power and press p momentarily to turn on the unit and begin the
power-up sequence. The power-up sequence initiates a series of displays on the unit. As shown
below, each display reflects a stage of the sequence. If the last display shows the idle screen, the
power up was successful; if the last display shows No Service, the unit is out of range or there is a
hardware or software problem.
If the vibrate function is enabled for incoming phone calls, voice mail, or message mail, the power-
up sequence includes a 500 ms. vibrate cycle.
1. Power-Up Display
Powering On
Note: After Powering On the
carrier logo will appear and
next the T9 text input logo.
2. No SIM Display
o
Insert SIM
Cancel
o
Enter SIM PIN
Code:
Delete
Note: SIM PIN code can be
cancelled. See Programming
Menu, page 5-7.
68P80400P65-O
1
d
-OR-
1 d
Figure 3-5. Power-Up Sequence Displays
3. Connecting Display
d
o
Please Wait
Connecting...
4. No Service Display
d
No service
5. Phone Ready Display
(Idle Screen)
1
o d
Ready
10/12 3:57pm
S
Mesg
Contcs
Note: Text that appears on Idle
screen depends on carrier.
3-1