Quick Reference Guide - Sharp UX-1300 Operation Manual

QUICK REFERENCE GUIDE
INSTALLATION
1. Connect the handset as shown.
2. Plug one end of the telephone line into the
"TEL. LINE" jack on the rear of the fax, and
the other end into your telephone wall jack.
3. Plug the power cord into a grounded, 120
V outlet.
INSTALLATION WITH AN EXTENSION
TELEPHONE
4. Remove the seal covering the "TEL. SET"
jack on the rear of the fax. Connect an ex-
tension telephone to the "TEL. SET" jack.
ENTERING YOUR NAME AND
NUMBER
The law requires your name and fax number
to appear on all documents you send. To pro-
gram your fax to do this automatically, follow
the steps below:
1. Press the FUNCTION key and then press
13":
FUNCTION
"ENTRY MODE" will appear in the ee
2. Press the "#" key twice
"OWN NUMBER SET" will appear in the
display.
3. Press the START key.
START
4, Enter your fax number (max. of 20 digits)
by pressing the number keys.
@ If you make a mistake, press the
HOLD/SEARCH key to move the cursor
back to the mistake, then enter the correct
number or letter. (To move the cursor for-
ward, press the SPEAKER key.)
5. Press the START key: |
6. Enter your name by pressing the appropri-
ate number keys as shown below. Press
each key one or more times until the de-
sired letter appears in the display.
peeeceecs: --)
case shift key
REDIAL
HOLDIBEAHCH
(J <— Moves cursor to
SPEAKER the left.
Moves cursor to
the right.
Press either key one or more times to select
and enter a symbol.
@ Enter "Q" with the "7" key, and "Z" with the
"9" key (these are not marked on the ma-
chine). Enter a space with the "1" key.
@ To enter two letters in succession which re-
quire using the same key, press the
SPEAKER key after entering the first let-
ter.
Example: To enter "ABZ Co.", press:
"2" twice for the letter A,
Press SPEAKER to move the cursor to the
right,
"2" three times for the letter B,
"Q" five times for the letter Z,
"1" twice for a space,
"2" four times for the letter C,
Press REDIAL for a lower case letter,
"6" four times for the letter o,
"#" once for a period.
7. When finished, press the START key and
then the STOP key
(See Page 2-4 of your operation manual.)
QUICK REFERENCE GUIDE
Quick-i