Using The Answering Machine - Sharp UX-1300 Operation Manual

4 USING THE ANSWERING MACHINE
Activating the answering machine
Activate the answering machine before you go out as follows:
Press the RECEPTION MODE key one
or two times to set the reception mode to
e If no general outgoing message has
been recorded, an alarm will sound
and the reception mode will change to
TEL. Record a general outgoing
message as described in "Answering
Machine Set-up" in Chapter 2.
Note: If the memory is full from messages previously recorded, MEMORY IS FULL
will appear in the display. To set the reception mode to T.A.D., you must
first erase some or all of the stored messages.
When the reception mode is set to T.A.D., the UX-1300/1400 will answer incoming
calls after two rings if it has received at least one incoming message, or after four
rings if no messages are received. (For more information, see "Toll Saver" in
"Remote Operations" in this chapter.)
Note: In T.A.D. mode, the machine will automatically switch to fax reception if it de-
tects a period of silence longer than six seconds after answering a call. For
this reason, if a caller pauses for this length of time while leaving a mes-
sage, they will be cut off.
Listening to received messages
When you return, the display will show the number of messages recorded in each
box. Listen to them as follows:
1 D/DDI Press the PLAY/SKIP key.
PLAY/SKIP
a e If you only want to listen to new
messages (messages not previously
listened to), continue to hold the
PLAY/SKIP key down for at least two
seconds.
USING THE ANSWERING MACHINE 4-1