Removing Excess Humidity - Danby DAC6304DE Owner's Instructions Manual

ii_i _ i ii i_iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiil
Remote Control Contro Panel
If the atmosphere in your room is very humid or damp, you can remove
excess humidity without lowering the room temperature too much.
1 If necessary, press the _ (On/Off) button.
Result: • The air conditioner starts up in the Cool mode.
• The unit beeps.
The air conditioner is fitted with a protection mechanism to pre-
vent the unit from being damaged when it is started immediately
after being:
• Plugged in
• Stopped
It will start up normally after three minutes.
Mode
If the temperature is not displayed at the top of the control panel, press
the _ button on the control panel one or more times until it
appears.
Result: • The unit beeps each time you press the _ button.
• The air conditioner runs in Dry mode.
You can change modes at any time.
Temp,
To adjust the temperature, press the I'--Z--I or_ buttons one or
more times until the required temperature is displayed.
Possible temperatures are between 18°C and 30°C inclusive.
Result: • Each time you press the _ or _ buttons:
- The temperature is adjusted by 1°C
- The unit beeps
• The air conditioner starts removing the excess humidity;
the quantity of air is adjusted automatically.
4 To control the direction of the air flow, refer to page 11.
@