Identifying Codes Found Using The Search Procedure; Setting The Sleep Timer - X10 SUPERREMOTE UR19A Owner's Manual

*Note: You might have to press
CHANNEL+ many times (50+). If the
device does not have a Channel Up
function, use the PLAY button (VCR only)
or the POWER button.
I C
DENTIFYING
S P
THE EARCH ROCEDURE
1. Press and hold the
SETUP until the LED
indicator lights
steadily. Release
Setup button.
2. Press the mode
button that matches
the equipment you
wish to identify. The
LED blinks once.
3. Press and release
SETUP. The LED
blinks once.
4. To find the first
digit, press each
number button from
0 to 9 until the LED
blinks. The number
you pressed is the
first digit of the
code.
5. Press each number
button from 0 to 9
again as above to
find the second
digit.
6. Press each number
button in turn to
find the third digit.
When the third
digit has been
found, the LED will
go out.
ODES FOUND USING
24
S S
ETTING THE LEEP
The Sleep Timer automatically turns off the
TV after the time you set. Press the TV
button, then follow the instructions below
to set the Sleep Timer:
1. Press and hold
TIMER until the LED
indicator lights
steadily. Release
TIMER button.
2. Use the number
buttons to enter the
sleep time required
(1 to 99 minutes).
3. Press ENTER to
confirm the setting.
Note: Take care to leave the remote
pointing at the TV to ensure it turns off the
TV at the time you set.
T
IMER
25