Lamp Module; Ontrolling; Odules - X10 MK19A Owner's Manual

L L L L L M M M M M
AMP AMP AMP AMP AMP ODULE ODULE ODULE ODULE ODULE
The Lamp Module (sold separately) may
be used to control any incandescent
lamp rated up to 300W. It is not suitable
for other types of lamps such as
fluorescent or energy saving lamps, or
lamps which include a dimmer control.
Caution: Do not connect an appliance
such as a coffee pot or heater to the
Lamp Module. It may damage the
Module and the appliance and could
cause a fire hazard.
1. 1. 1. 1. 1. Set the House Code
to 'A' and the Unit
Code to '2.'
2. 2. 2. 2. 2. Plug a lamp into
the Lamp Module.
3. 3. 3. 3. 3. Plug the Lamp
Module into a
convenient AC
outlet.
4 0 4 0
4 0 4 0 4 0
C C C C C

ONTROLLING

ONTROLLING ONTROLLING ONTROLLING ONTROLLING
M M M M M

ODULES

ODULES ODULES ODULES ODULES
If you have installed the Transceiver
Module (sold separately) you can control
it and other X10 modules as follows:
1. 1. 1. 1. 1. Press and release
the X10 button.
2. 2. 2. 2. 2. Use the number
buttons to enter
the Unit Code
number of the
chosen module.
(You do not need
to enter '0' first for
a single digit
number.)
3. 3. 3. 3. 3. Press the appro-
priate button for
the function you
require (see below).
X10 FUNCTIONS:
On: CHANNEL +
Off: CHANNEL –
Bright:
Dim:
All Lights On:
All Modules Off:
Note: You cannot dim or brighten an
Appliance Module. If the module was off
and you press Bright or Dim (VOLUME+
or VOLUME-) this will simply turn the
module on.
4 1 4 1
4 1 4 1 4 1
X10 X10
X10 X10 X10
VOLUME +
VOLUME –
POWER
MUTE