Bosch MRC23EVSK Operating/Safety Instructions Manual page 20

BM 2610004573 03-12_BM 2610004573 03-12 6/26/12 7:16 AM Page 19
The router can be guided through the work in
any of several ways. The method you use
depends, of course, on the demands of the
particular job and on convenience.
Many edge-forming router operations can be
done using bits that have bearings.
For routing operations such as grooving or
dadoing, it is often necessary to guide the tool
in a line parallel to a straight edge. One
method of obtaining a straight cut is to securely
clamp a board or other straightedge to the
work surface, and guide the edge of the router
sub-base along this path (Fig. 15).
DELUXE ROUTER GUIDE
The Bosch deluxe router guide is an optional
accessory that will guide the router parallel to
a straight edge or allow you to create circles
and arcs.
The deluxe router guide is supplied with two
rods and screws to fasten the guide (Fig. 16).
In addition, it features a fine adjustment knob
and indicator for accurately positioning the
edge guide relative to the bit. With the guide
installed and adjusted, the router should be
FIG. 16
6mm Wing
Screws
Base
Desired
Width
Guiding the Router
Cut
Workpiece
FIG. 15
fed normally, keeping the guide in contact
with the edge of the workpiece at all times.
The deluxe router guide may also be
positioned directly under the router base for
operations where a cut is needed close to or
at the edge of the work.
The deluxe router guide includes a dust
extraction hood and the VAC002 vacuum
hose adapter.
For complete instructions on installation and
operation, please refer to the instructions
which are included with this accessory.
FEED
DIRECTION
Fine Adjustment
Knob
-19-
FEED
DIRECTION
Board
Guide
Securely Clamp
Board Guide
Fine Adjustment
indicator
Router
Guide
Rods