Bosch MRC23EVSK Operating/Safety Instructions Manual page 12

BM 2610004573 03-12_BM 2610004573 03-12 6/26/12 7:16 AM Page 11
FIG. 6
Press Macro
Depth
Adjustment
Lever
INSTALLING MOTOR IN FIXED BASE
1. Release the base clamp lever.
2. Line up the MOTOR-TO-BASE 5V
CONTROL CONNECTION TRACK with the
slot in the fixed base and slide the motor into
the carriage.
3. Motor will first slide past the base's motor
release button catch.
4. While holding down the macro depth
adjustment lever, push the motor into the
base until it reaches the approximate
desired depth.
5. Release the macro depth adjustment lever
and slide the motor forward or back as
needed until the macro adjustment system's
"catch" springs into the macro adjustment
detent notch.
6. Set final height position as described in
FIXED BASE DEPTH ADJUSTMENT.
7. After making depth adjustments, re-clamp
the motor by pressing base clamp lever into
closed position.
REMOVING MOTOR FROM FIXED BASE
1. Hold router in horizontal position, open base
clamp lever.
2. Press and hold macro depth adjustment
lever and gently pull motor outward
3. Press secondary motor-release button and
pull motor out of fixed base.
MRF01 Fixed Base Preparation
Release Base
Clamp Lever
A
B
-11-
Motor Release
Button
SLIDE MOTOR
IN BASE
Fine Adjustment
Knob
FIXED BASE DEPTH ADJUSTMENT
The MRF01 Fixed Base is equipped with a
true micrometer type fine adjustment
mechanism, which can be used in any position
and provides precise adjustment of the router
bit position for unmatched accuracy. When the
tool is lowered to the approximate position
desired, this device may be adjusted to
precisely set the final bit position.
This base also features three horizontal
notches on both sides of the motor housing for
coarse adjustments. The notches are spaced
1/2" apart which allows you to quickly lower or
raise the tool depth in three 1/2" increments.
(Approximately 12.7 mm), by simply
depressing the coarse adjustment release
lever.
TO ADJUST DEPTH
NOTE: All depth adjustments must be made
with the base clamp lever released.
1. Open the base clamp lever to release the
motor.
2. MACRO DEPTH ADJUSTMENT:
To make a large depth adjustment, depress
macro adjustment release lever and raise or
lower the motor to the approximate desired
depth until it engages in the closet notch.
There are three notches in the motor
housing which are spaced 1/2" to facilitate
this adjustment.