12 SERVICE WORK ON THE CHASSIS
12.19
70
W00327-10
W00328-10
W00329-10
W00330-10
Installing the shock absorber
W00330-11
Main work
–
Loosen and remove screws
turn signal plug-in connections.
–
2
Loosen screws
and screws
–
Take off the license plate holder with tail light toward the rear.
–
Loosen and remove screw
–
Loosen and remove screw
–
Carefully take off the right side cover to the side.
The right side cover also engages behind the spoiler.
–
Carefully remove retaining springs
–
Remove rear half of manifold
–
8
Remove screw
and lower the rear wheel with the link fork
as far as possible without blocking the rear wheel. Secure the
rear wheel in this position.
–
9
Remove screw
, push splash protector
remove the shock absorber.
Main work
–
1
Push splash protector
absorber. Mount and tighten screw
Guideline
Screw, top
M12
shock absorber
–
Mount and tighten screw
Guideline
Screw, bottom
M12
shock absorber
1
. Disconnect the tail light and
3
and remove them.
4
.
5
.
6
.
7
to the rear.
bk
to the side, and
to the side and position the shock
2
.
80 Nm (59 lbf ft)
Loctite
®
3
.
80 Nm (59 lbf ft)
Loctite
®
2701™
2701™