Table of Contents
Advertisement
Connecting
6.2 Connector locations
Power connector and DVI connectors
The power connector and the DVI connectors are located within the connector panel under a
cover on the rear of the monitor.
5 V connections
The device has two 5 V outputs which can be used to supply external devices.
Grounding screw
The additional protective ground is connected here.
Service connection
The service connection is used by service personnel for loading software updates.
Serial interface for photometer
CAUTION
• Only photometers tested for calibrating the equipment may be connected to the serial
• Only service personnel or those trained by them may connect or disconnect a device
• A photometer must not be connected in the presence of the patient.
The serial interface is freely accessible next to the fan at the center.
Serial Spot Meters and Advanced or Universal Serial Luminance Meters have been
approved as photometers.
See also
General safety notes (Page 8)
DVI connector (Page 28)
Controls and connectors (Page 42)
Power supply connection (Page 27)
26
interface.
from the unit.
RadiForce® LS560W
Instruction Manual, 04/2012, A5E10000920A-006
Advertisement
Table of Contents
