Table of Contents
Advertisement
TROUBLESHOOTING
Your dishwasher may not work properly.
Before contacting the Service Centre check if the problem can be solved by going through the following list.
PROBLEMS
POSSIBLE CAUSES
The appliance has not been plugged
The dishwasher
in properly.
won't start
Power outage.
or does not
respond to
The dishwasher door is not closed.
commands.
It does not respond to commands.
The dishwasher
The wash cycle has not finished yet.
won't drain.
The drain hose is bent.
The sink drain pipe is blocked.
The filter is clogged up with food
residues.
The dishwasher
The dishes are rattling against each
makes
excessive
An excessive amount of foam has
noise.
been produced.
The crockery has not been arranged
The dishes are
properly.
not clean.
The spray arms cannot rotate freely,
being hindered by the dishes.
The wash cycle is too gentle.
An excessive amount of foam has
been produced.
The cap on the rinse aid compartment
has not been shut correctly.
The filter is soiled or clogged.
There is no salt.
MAINTENANCE AND TROUBLESHOOTING GUIDE
For more information, maintenance procedures and tro-
ubleshooting, see the Use and Care Guide
The Use and Care Guide can be obtained by:
• After-Sales Service; phone number see in warranty
booklet.
• download from website: docs.indesit.eu
• use QR code
TECHNICAL DATASHEET
The technical data containing the energy consumption
data can be downloaded from the website:
docs.indesit.eu
8
SOLUTIONS
Insert the plug into the socket.
The dishwasher starts automatically when the power returns.
Vigorously push the door until you hear the "click".
Switch off the appliance by pressing the ON/OFF button, switch it back
on after approximately one minute and reset the program.
Wait until the wash cycle finishes.
Check that the drain hose is not bent
Clean the sink drain pipe.
Clean the filter (see CLEANING THE FILTER ASSEMBLY).
Position the crockery correctly
The detergent has not been measured out correctly or it is not suita-
ble for use in dishwashers (see FILLING THE DETERGENT DISPENSER).
Reset dishwasher by pressing the DRAIN button (see OPTIONS AND
FUNCTIONS) and run new program without detergent.
Arrange the crockery correctly
Arrange the crockery correctly
Select an appropriate wash cycle (see PROGRAMS TABLE).
The detergent has not been measured out correctly or it is not suitable
for use in dishwashers (see FILLING THE DETERGENT DISPENSER).
Make sure the cap of the rinse aid dispenser is closed.
Clean the filter assembly
(see CARE AND MAINTENANCE).
Fill the salt reservoir
(see FILLING THE SALT RESERVOIR).
CONTACTING AFTER-SALES SERVICE
When you contact the After-Sales Service, you must pro-
vide the codes shown on the rating plate attached to the
left or right side inside the door of the dishwasher.
The phone number is listed
in the warranty booklet or on the
website:
www.indesit.com
(see INSTALATION INSTRUCTION)
(see LOADING THE RACKS).
(see LOADING THE RACKS).
(see LOADING THE RACKS).
:
400011352206
03/2019 jk - Xerox Fabriano
.
IEC 436
Advertisement
Table of Contents
