Table of Contents
Advertisement
OPTIONS AND FUNCTIONS
OPTIONS can be selected directly by pressing the corresponding button (see CONTROL PANEL).
If an option is not compatible with the selected program see PROGRAMS TABLE, the corresponding LED flashes rapidly 3 times
and beeps will sound. The option will not be enabled.
HALF LOAD
If there are not many dishes to be washed, a half load
cycle may be used in order to save water, electricity and
detergent. Select the program and press the HALF LOAD
button: the indicator light will light up. Press the HALF
LOAD button to deselect this option.
Remember to halve the amount of detergent.
TABLET
This setting allows you to optimize the performance of
the program according to the type of detergent used.
Press the TABLET button (the indicator light will switch
on) if you use combined detergents in tablet form (rinse
aid, salt and detergent in 1 dose).
If you use powder or liquid detergent, this option
should be off.
4
DELAY
It is possible to delay the start time of the cycle by a
period of time between 1 and 24 hours:
1. Select the desired wash cycle and any other options
required; press the DELAY button. The indicator light will
go on. Use the same button to select when the wash
cycle will start (h01, h02 etc.).
2. Confirm the selection using the START/PAUSE button
to start the countdown.
3. Once this time has elapsed, the DELAY indicator light
goes off and the wash cycle begins.
To deselect the DELAY option, press the DELAY button
until the text OFF appears.
The Delay function cannot be set once a wash cycle
has been started.
CoolDry
CoolDry is a convection drying system which automatically opens the
door during/after drying phase to ensure exceptional drying perfor-
mance every day. Door opens at the temperature that is safe to your
kitchen furniture, thus door will not be opened when the option of
SANI RINSE or SHORT TIME are on.
As additional steam protection, special designed protection foil is ad-
ded together with the dishwasher (depending on the model type - can
be the need to buy it). To see how to mount protection foil please refer
to (INSTALLATION GUIDE).
CoolDry functionality could be disabled by the user as follows:
• To DISABLE: Switch On, then switch Off the machine. Keep the P
button pressed for 5 sec., at the end of 5 sec the dishwasher plays
a short beep. Switch On the machine, the display shows « oOF »
and plays a long beep.
• To ENABLE: Switch On, then switch Off the machine. Keep the P
button pressed for 5 sec., at the end of 5 sec the dishwasher plays
a short beep. Switch On the machine, the display shows « oOn »
and plays 3 short beeps.
Advertisement
Table of Contents
