Misc - Snapper 0 Series Safety Instructions And Operator's Manual

€
,E
How to Install the Wheels
If the wheels must be removed for service, make sure they
are installed as follows.
Front Wheel:
1. Make sure the valve stem is to the outside of the
tractor. Slide the front wheel on the spindle (See
Figure 44).
2. Fastenthe front wheel with washer and cotter pin.
Bend the ends of the cotter pin apart to keep the front
wheel on the spindle.
3. If your model has hubcaps, installthe hubcaps. Make
sure the washers hold the hub caps in place.
Figure 44. Front wheelassembly
A - Cotter pin
B - Hub cap
C - Valvestem
D - Front wheel
E- Spindle
F- Washers
Rear Wheel:
1. Install the washers and spacer onto the axle as shown
in Figure 45.
2. Mount the square key in the key slot (See Figure45).
3. Make sure the valve stem is to the outside of the
tractor. Align the slot in the rear wheel with the square
key. Slide the rear wheel on the axle.
4. Fastenthe rear wheel with washer and e-ring.
5. If your model has hubcaps, install the hubcaps. Make
sure the washers hold the hub caps in place.
Figure 45: Rear wheel assembly
A - Rear wheel
B - Hub cap
C - E-ring
D- Washer
E - Valvestem
F- Spacer
G- Washer
H - Square key
I - Key slot
J - Axle
How to Replace the Fuse
If the fuse is blown, the engine will not start. The location of
the fuse is behind the panel between the engine and the
control console. Removethe fuse and replace with an
automotive fuse of equivalent rating (Figure 46).
Figure 46: Fuse location
A - Automotive fuse
38
English
www.snapper.com