Adjustments - Snapper 0 Series Safety Instructions And Operator's Manual

.E
_E
10. Install the mower deck. See "How To Install The Mower
Deck".
.
A new blade will cut better than a badly worn blade.
Every three years, have an authorized service person
inspect the blade or replace the old blade with an
original equipment blade.
S
I
D. ©
Figure 20. Blade assembly
A - Blade adapter
7. Assemble the blade according to the instructions "How
To Remove And Install The Blade".
B - Belleville washer (Outside nm must be against the blade.)
C - Nut
D- Washer
E - Blade
How to Sharpenthe Blade
,_ WARNING:Vibrationcan be causedif the blade is
not correctlybalancedor if the blade is damaged. A
blade that is damagedwith crackscan break and
causean accident.
Figure 21: Sharpening the blades
A - Screwdriver
B - Blade
C - File
D - Ground
E - Blade is balanced when parallel to the ground
Keep a sharp edge on the blade. A blade that is not sharp
will cause the tips of the grass to become brown.
1. Sharpen the blade two times a year or every 25 hours.
2. Remove the blade according to the instructions in
"How To RemoveAnd Install The Blade".
3. Cleanthe blade with a brush, soap and water. Check
the blade. Look for cracks, nicks, or other damage.
Replace a badly worn or damaged blade with an
original equipment blade. See an authorized service
center in your area.
4. Sharpen the blade with a file (Figure 21). Make sure
you keep the original bevel angle.
5. Make sure the blade is balanced. Use a screwdriver
and hold the blade parallel to the ground (Figure 21). A
blade that is balancedwill stay parallel to the ground.If
the blade is not balanced,the heavy end will rotate
toward the ground. Sharpen the heavy end until the
blade is balanced.
Adjustments
How to Adjustthe Blade RotationControl(42" Models)
,_ WARNING:To preventan injury, the blade rotation
controlmust operatecorrectly.
In normal usage, the blade rotation controlwill not require
an adjustment. However, if the cutting performance
decreasesor the quality of cut is poor, make the following
changes.
1. When you mow, make sure the throttle control in in the
FAST position.
2. Move the blade rotationcontrolto the DISENGAGE
position (Figure 22).
3. Stop the engine. Disconnect the wire from the spark
plug.
22
English
www.snapper.com