Misc - Snapper LT23460AWS Safety Instructions & Operator's Manual

How to Install the Wheels
If the wheels must be removed for service, make sure they
are installed as follows.
Front Wheel:
1. Make sure the valve stem is to the outside of the
tractor. Slide the front wheel on the spindle (See Figure
39).
2. Fasten the front wheel with washer and cotter pin. Bend
the ends of the cotter pin apart to keep the front wheel
on the spindle.
3. If your model has hub caps, install the hub caps. Make
sure the washers hold the hub caps in place.
A
B
C
Figure 39: Front wheel assembly
A - Cotter pin
B - Hub cap
C - Valve stem
D - Front wheel
E - Spindle
F - Washers
Rear Wheel:
1. Make sure the valve stem is to the outside of the
tractor. Mount the rear wheel to the hub assembly with
the three bolts. (See Figure 40.)
2. Tighten the bolts to a torque of 50 ft. lbs.
36
F
E
D
A
D
Figure 40: Rear wheel assembly
A - Rear wheel
B - Valve stem
C - Hub assembly
D - Bolt
C
B
www.snapper.com