Table of Contents
Advertisement
Section 5 - ADJUSTMENTS
& REPAIR
Ik
DANGER
Exercise
EXTREME
CAUTION
when
making
this I
adjustment, due to close proximity of moving parts.
I
5.1
NEUTRAL POSITION ADJUSTMENTS
The motion control levers control the movement
and stopping of the machine.
Move the control
levers to the center or neutral
position to stop
machine.
IMPORTANT:
Always
return both motion control
levers
with
hand
assistance
to
the
neutral
position,
If
machine
does
not
come
to
a
complete
stop or machine
has movement
when
control
levers
are moved
to the neutral
lock
position,
adjustment
must be made.
1. Turn key to "OFF" position.
2. Move motion control levers to the neutral lock
position. Refer to Figure 3.7.
3. Raise both rear wheels off the ground. Secure
machine with safety blocks.
4. Remove cover screen to expose top of hydro
pumps and linkages. See Figure 5.1.
5. Remove both fans from top of hydro pumps.
6. Disconnect
motion lever connecting
rods from
hydro pump activation assembly. See Figure 5.2.
iREMOVESCREEN
FIGURE 5.1
7. Turn key to start position and start machine.
Move engine speed control to the Rabbit "FAST"
position
8. Disengage parking brake.
9. Both wheels should not have any movement, not
rotating.
10. If wheel(s) are rotating, loosen the hydro pump
activation assembly retaining screw. Move activation
assembly forward or rearward to stop rotation of
wheel. Retighten retaining screw. Repeat this step for
other hydro pump. See Figure 5.3.
11. Stop engine.
REMOVE MOTION CONTROL
LEVER CONNECTING
ROD
HYDRO PUMP
ACTIVATION
ASSEMBLY
FIGURE 5.2
MOVE ACTIVATION
ASSEMBLY
REARWARD
OR
FORWARD
TO ACHIEVE
NEUTRAL
FIGURE 5.3
LOOSEN ACTIVATION
ASSEMBLY
RETAINING
SCREW
(Continued
On Next Page)
19
Advertisement
Table of Contents
