Embroidering around holes
1m.
The complete equipment for embroidering around holes, which is not part of the stan¬
dard accessories, comprises the following components :
63 06 62
Hole embroidery foot
63 06 60
Needle plate complete with slide for holes
64 12 01-01 Embroidery ring
54 11 05
Square piercer
64 11 06
Hound piercer
This simple device permits sewing fashionable " Broderie Anglais " and circular em¬
broideries on the Bernina-Record and 632. It allows sewing around holes of various
sizes and making circular embroideries up to approximately 1 inch in di ante ter. In
both cases the stitch width may be varied during the operation of sewing around.
For hole embroidering set the machine as follows :
1. set needle to left position by turning lever 13 (Fig.2) to the left:
2. lower feed dog by turning control lever 17 (Fig. 2) to the left for darning symbol;
3. replace ordinary needle plate with hole embroidery needle plate complete with slide,
attach hole embroidery presser foot.
Always use the em¬
broidery
frame.
We
recommend
winding
strips of cloth around
its outer ring to obtain
better tension of the
material and to pre¬
vent damage to it. On¬
ly after clamping the
material in such man¬
ner, punch the holes
with the piercers sup¬
plied. It is of advan¬
tage to previously ma rk
the holes on the mate¬
ria] by means of a
pencil or the like.Then
place the material un¬
der the hole embroi¬
dery foot so that the
guide pin of the slide
projects through the
hole. As mentioned be¬
fore, the needle is to
set
in
left
position
(page 44, Fig. 23 b).
Position of slide for
hole embroidery
Fin. 76
Embroidering is
performed in the
embroidery frame
Fig. 76