Operating Tips - Toro Greensmaster e1021 Operator's Manual

Service Menu
Menu Item Description
Hours Lists the total number of hours that the
machine has been turned on.
Power Use Lists the instantaneous power delivered by
the battery in Watts.
Battery Charge Lists the current battery charge as a percent
of capacity.
Battery Current Lists the instantaneous current delivered by
the battery in Amps.
Battery Volts Lists the battery potential in volts.
Total Usage Lists the total amount of battery usage in watt
hours.
Capacity List the current battery capacity in amp hours.
Battery Hours Lists the total amount of hours that the battery
has been active.
Backlap Sets the machine in Backlap Mode.
Diagnostics Menu
Menu Item Description
Key On Indicates whether the ignition key is on or off.
Traction Indicates whether the traction bail is engaged
or disengaged.
Throttle Indicates the throttle control setting in Volts
(used to calculate the target rpm).
Bail Indicates the bail control settings in Volts.
Target rpm Lists the desired motor rpm as indicated by
the speed control setting.
Motor rpm Lists the actual motor rpm.
12V Supply Lists the sensor supply voltage #1 of the
controller.
5V Supply Lists the sensor supply voltage #2 of the
controller.
CAN Bus Lists the machine communication bus status.
Settings Menu
Menu Item Description
Language Use this setting to change the language used
on the InfoCenter.
Units Use this setting to change the units used
by the InfoCenter. The menu choices are
English and Metric.
LCD Backlight Use this setting to increase or decrease the
brightness of the LCD display.
Use this setting to change the contrast
LCD Contrast
between the dark and light areas of the LCD
display.
About Menu
Menu Item Description
Model
Lists the model number of the machine.
SN Lists the serial number of the machine.
S/W Rev Lists the revision number of the machine
software.
Note:
If you inadvertently change the language
or contrast to a setting where you can no longer
understand or view the display, contact your
authorized Toro distributor for assistance in resetting
the display.

Operating Tips

Important:
Grass clippings act as a lubricant
when mowing. Operating the cutting unit
excessively without grass clippings can damage
the cutting unit.
•
Mow the greens in a straight back-and-forth
direction across the green.
•
Avoid circular mowing or turning the machine on
the greens areas to prevent scuffing.
•
Turn the machine off the green by raising the
cutting reel (pushing the handle down) and
performing a tear-shaped turn on the traction drum
(Figure 24).
23