Toro Greensmaster e1021 Operator's Manual page 16

InfoCenter LCD Display
The InfoCenter LCD display shows information about
your machine and battery pack, such as the current
battery charge, speed, diagnostics information, and
more (Figure 16).
For more information, refer to
LCD Display (page 21).
Lift-Assist Handle
Use the lift-assist handle
adjusting the handle height or to raise and lower the
kickstand.
Handle-Height Adjuster
Use the handle-height adjuster
the handle height to a comfortable operating position.
Pull up on the adjuster and use the lift-assist handle
to raise or lower the handle height.
Figure 17
1. Handle-height adjuster
Kickstand
The kickstand (Figure
the machine. Use the kickstand when you install or
remove the transport wheels or the cutting unit.
•
T -W
RANSPORT HEEL
To use the kickstand to install the transport wheels,
put your foot on the kickstand while pulling up and
back on the lift-assist handle
Using the InfoCenter
(Figure 16) to help with
(Figure 17) to move
18) is mounted to the rear of
-S position:
ERVICE
(Figure 18).
CAUTION
The machine is heavy and can cause back
strain if lifted improperly.
Put your foot pressure down on the
kickstand and use only the lift-assist
handle to raise the machine. Attempting to
raise the machine onto the kickstand any
other way can cause injury.
•
C -U
UTTING NIT
To prevent the machine from tipping backward
when removing the cutting unit, lower the kickstand
and push out the spring pin so that it keeps the
kickstand in the position shown in
•
Retracting the kickstand to the S
position:
1. Keep your foot on the kickstand while
lowering the traction drum to the ground.
2. Remove your foot from the kickstand and
allow space for the kickstand to retract to the
S
TORAGE
g271081
1. Lift-assist handle
2. Kickstand—S
position
16
-S position:
ERVICE
Figure
position.
Figure 18
3. Kickstand—T
S
ERVICE
TORAGE
19.
TORAGE
g343381
-W
RANSPORT HEEL
position