Procaucoing Ec Ciscccnscccseacesvisseadisbidnestéaceiveucscsusiscpsduetien - Panasonic SC-AK15 Operating Instructions Manual

Before use ae
| Precautions
Before using this unit please read these operating instructions care-
fully. Take special care to follow the warnings indicated on the unit
itself as well as the safety suggestions listed below.
Afterwards keep them handy for future reference.
=k
. Power Source—The unit should be connected to power supply
only of the type described in the operating instructions or as
marked on the unit.
Polarization—lf the unit is equipped with a polarized AC power
plug (a plug having one blade wider than the other), that plug will
fit into the AC outlet only one way. This is a safety feature. If you
are unable to insert the plug fully into the outlet, try reversing the
plug. If the plug should still fail to fit, contact your electrician to
replace your obsolete outlet. Do not defeat the safety purpose of
the polarized plug.
Power Cord Protection—AC power supply cords should be
routed so that they are not likely to be walked on or pinched by
items placed upon or against them. Never take hold of the plug
or cord if your hand is wet, and always grasp the plug body when
connecting or disconnecting it.
Nonuse Perlods—When the unit is not used, turn the power off.
When left unused for a long period of time, the unit should be
unplugged from the household AC outlet.
N
w
>
. Outdoor Antenna Grounding—lf an outside antenna is con-
nected to the receiver, be sure the antenna system is grounded
so as to provide some protection against voltage surges and built-
up static charges. Section 810 of the National Electrical Code,
ANSI/NFPA No. 70-1990, provides information with respect to
proper grounding of the mast and supporting structure, ground-
ing of the lead-in wire to an antenna discharge unit, size of
grounding conductors, location of antenna-discharge unit, con-
nection to grounding electrodes, and requirements for the ground-
ing electrode. See figure below.
—_
ANTENNA
LEAD IN
WIRE
ANTENNA
DISCHARGE UNIT
SERVICE
EQUIPMENT
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAMPS
i eae SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H}
NEC-NATIONAL ELECTRICAL CODE
2. Water and Moisture—Do not use this unit near water—for ex-
ample, near a bathtub, washbow!, swimming pool, or the like.
Damp basements should also be avoided.
3. Heat—The unit should be situated away from heat sources such
as radiators and the like.
It atso should not be placed in temperatures less than 5°C (41°F)
or greater than 35°C (95°F).
4. Condensation—Moisture may form on the lens in the following
conditions...
e immediately after a heater has been turned on.
ein a steamy or very humid room.
«when the unit is suddenly moved from a cold environment to a
warm one.
If moisture forms inside this unit, it may not operate properly. To
correct this problem, turn on the power and wait about one hour
for the moisture to evaporate.
1. Ventilation—The unit should be situated so that its location or
position does not interfere with its proper ventilation. Allow 10 cm
(4") clearance from the rear of the unit.
2. Foreign Material—Care should be taken so that objects do not
fall into and liquids are not spilled into the unit. Do not subject
this unit to excessive smoke, dust, mechanical vibration, or shock.
3. Magnetism—The unit should be situated away from equipment
or devices that generate strong magnetic fields.
4, Stacking—Do not place heavy objects, other than system com-
ponents, on top of the unit.
5. Surface—Place the unit on a flat, level surface.
6. Carts and Stands—The unit should be used only with a cart or
stand that is recommended by the manufacturer. i
The unit and cart combination should be moved
with care. Quick stops, excessive force, and un-
even surfaces may cause the unit and cart combi-
nation to overturn.
. Wall or Ceiling Mounting—The unit should not be mounted to
a wall or ceiling, unless specified in this operating instructions.
(See page 35 for details.)
~
Clean the cabinet, panel and controls with a soft cloth lightly mois-
tened with mild detergent solution.
Do not use any type of abrasive pad, scouring powder or solvent
such as alcohol or benzine.
. Damage Requiring Service—The unit should be serviced by
qualified service personne! when:
(a) The AC power supply cord or the plug has been damaged;
or
(b) Objects have fallen or liquid has been spilled into the unit; or
(c) The unit has been exposed to rain; or
(d) The unit does not appear to operate normally or exhibits a
marked change in performance; or
(e} The unit has been dropped, or the enclosure damaged.
. Servicing—The user should not attempt to service the unit be-
yond that described in the operating instructions. All other serv-
icing should be referred to an authorized service personnel.
(Only for U.S.A.)
Call 1-800-211-7262 for the address of an authorized factory
servicenter.
=_
N