Setting The Clock; Setting The Sleep Timer .Ssscessssssne Sadueomisctie - Aiwa NSX-S223 Operating Instructions Manual

The clock is displayed. (The ":" between the hours and minutes
flashes.) When the power cord is plugged into an AC outlet
for the first time after purchase or when the clock setting is
- canceled due to a power failure, the entire clock display
. flashes.
1 Press Ill or ENTER.
When using the remote control, press CLOCK while pressing
SHIFT.
2 Within 4 seconds, turn MULTI JOG to designate
the hour and the minute.
Turning MULTI JOG changes both the hour and the minute.
<4 or PP is also available instead of MULTI JOG. Holding
these buttons down will vary the time rapidly.
3 Press UI or ENTER.
The clock starts from 00 seconds.
To restore an original clock setting
Press CLOCK while pressing SHIFT on the remote control before
completing step 3 to restore the previous time setting. This
cancels any new setting.
To view the clock when another display is in the display
Press CLOCK while pressing SHIFT on the remote control. The
time is displayed for 4 seconds and then the original display
reappears. However, the clock cannot be displayed during
recording.
To switch to the 24-hour standard
Press CLOCK while pressing SHIFT on the remote contro! and
then press ll within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
If the display flashes when the clock is displayed, it indicates
that the clock has stopped due to a power failure or the removal
of the power cord. The current time needs to be reset.
20 ENGLISH
Use the remote control.
1 Press SLEEP while pressing SHIFT.
Specified time
displayed for 4 seconds. .
To cancel the sleep timer
Press SLEEP twice while pressing SHIFT so that "SLEEP oFF"
appears on the display. ;