Siemens SIMATIC NET SFP Operating Instructions Manual page 62

Approvals
Use of controls or adjustments or performance of procedures other than those specified herein
may result in hazardous radiation exposure.
Mechanical stability (in operation)
Pluggable transceiver IEC 60068-2-6 vibration
SFP
SFP+
SCP
STP
Installation guidelines
The devices meet the requirements if you adhere to the installation and safety instructions
contained in this documentation and in the following documentation when installing and
operating the devices.
• "Industrial Ethernet / PROFINET Industrial Ethernet" System Manual
support.industry.siemens.com/cs/ww/en/view/84922825)
• "Industrial Ethernet / PROFINET - Passive Network Components" System Manual
support.industry.siemens.com/cs/ww/en/view/27069465)
• "EMC Installation Guidelines" configuration manual
support.industry.siemens.com/cs/ww/en/view/60612658)
Personal injury and property damage can occur
The installation of expansions that are not approved for SIMATIC NET products or their target
systems may violate the requirements and regulations for safety and electromagnetic
compatibility.
Only use expansions that are approved for the system.
Note
The test was performed with a device and a connected communications partner that also meets
the requirements of the standards listed above.
When operating the device with a communications partner that does not comply with these
standards, adherence to the corresponding values cannot be guaranteed.
62
CAUTION
5 – 9 Hz: 3.5 mm
9 – 150 Hz: 1 g
1 octave/min, 20 sweeps
WARNING
IEC 60068-2-27 shock
15 g, 11 ms duration
6 shocks per axis
●
●
●
●
(https://
Operating Instructions, 10/2023, A5E02630804-18
●
●
●
●
(https://
(https://
Transceiver SFP/SFP+/SCP/STP