Focusing When Recording Movie; Macro Recording - Hitachi DZ-MV270A Instruction Manual

Focusing When Recording Movie
This DVD video camera/recorder auton-latically %cuses a subject at the center of screen (auto focus).
When tile DVD video carnera/recorder is turned oil, auto focus will always be set.
Focusing range
Yon can switch tile
display
mode
of on screen
information:
• On T (tele) side: approxirnately 3.6 %et (1 m) flora lens surf_ce to infinity
• On W (wide) side: approximately 3/8" (1 cm) from lens surf_ce to infinity
• How to install conversion lens (optional)
The installation screw diameter of this lens is 37 ram.
Conversion lens
(To remove)
Lens hood
\
(To attach)
1
Remove the lens hood Dora the DVD video cam _ Remove the lens cap Dora the conversion lens
era/recorder, and screw it all the way into the filter screw of
the DVD video camera/recordel:
Note: Be careful not to lose the lens hood
Note: _fthe _pti_na_ te_e-c_n_er_i_n _ens (D_-_L1) is atta_hed _ve_ the _ens` the ran_e where a subject is
focused at T end (telephoto side) will be fiom appioximately 18 feet (5 m) to infinite
Note: If the optional tele-convelsion lens (DZJL1) is attached over the lens, the four comers of screen will
be darker (vigneuing) on W (wide-angle) side when a subject is zoomed in
Macro Recording
Use the macro flmction when recording a small object fi'om close np position: You can shoot the subject
as close as approximately 3/8" (1 cm) from the lens surface, magnifying the image to fill the screen.
Aim the DVD video camera/recorder at the sub
ject, and press down the zoom lever to" W" con
trol side.
Note: Zoom can be used, but the subject may
not be focused, depending on the distance to the
subject
Note: The amount of light tends to be insufficient
during macro recolding: If the subject image istoo
dark, use additional lighting
48