Roland M-GS64 Owner's Manual page 75

MIDI IMPLEMENTATION
Channel Mode Message
° All Sound Off
Status Second Third
Benes BBs BOB
n= MIDI channel number: OH — FH (ch.) — ch.16)
'When this message is received, all currently-sounding notes on this corresponding chonnel will be turned off immedi-
ately.
This message is ignored when the "IDI receive switch" is OFF for each part.
* Reset All Controllers
Status Second Thidd
Bn 79H OCH
n= MEDI channel number: CH —~ FH (ch.1 — ch.16)
If this mesoge is received, the voles of fllowing cntalles wil be changed.
Controller Value
'Modulation O (off)
Yolume 127 (maximum)
Ponpat 64 (center)
Expression O (off)
Hold 1 O {off},
Channel pressure Otoff)
Pitch bend change O (center)
RPN Ho specified parameter, no value is changed.
NRPA No specified porameter, no value is changed.
* All note off
'Status Second = Third
Batt 78H OOH
n= MIDI chonnel number: OH — FH (ch.] — ch.i6)
When this message is recognized, all the note which have been turned on by "MID! note on" message are turned off.
However if Hold } or Sostenuto is on, the sound will be continued untill these are turned off,
* OMNI Off
Spotus Second» Third
Bait 7G OCH
= MIDI channel number: OH — FH (ch) — ch.16)
Recognized as "Al note of".
* OMNI On
totus Second Tid
Ball 70H 00H
v= HADI chonnel number: OH — FA (ch.] — ch.16)
This message is recognized os "All note off". (Sound Expansion Series doesn't recognize OMNI on.)
* MONO
Stotus Second Third
Bat TE mama
n= MIDI channel number: O8 — FH (ch.! — ch.16)
mm = number of mona: GOH — 10H (0 — 16)
"assign mode" of patch common is Switched to "SOLO."
Recognize cs "Al notes off", end ses each patch MODE4 (H = 1).
» POLY
Status Second Thicd
Bn 7H 0H
i= MIDI channel number 0H — FH (ch.1 — ch. 16)
Switched over "Assign mode" of patch common.
Recognized all notes off, ond set MODES at each patch.
14
System Realtime message
© Active sensing
Stotus
FEH
'When Sound Expansion Series receives an "Active sensing," it measures time intervals between incoming messages.
If the subsequent message does not come within 350 ms after the previous one, Sound Expansion Series will furn off
cll IDI - on notes as if it received "Reset all controllers," stop measuring message interval.
* System Exclusive message
status data bytes.
Fou iit, ddk,....,eeH
FH
FOH System exclusive
ii = manufacturer ID 41H (65)
dg, .., 2 = data: OOH — 7FH (0 —~ 127}
F7H: EOX (End of Exclusive/System common}
System exclusive message is ignored when "Receive Exclusive" of the system common is OFF.
Refer to section 3,4
System Exclusive Message for setting the Modes
"Data set 1 (DTT), the Roland's Exclusive format, is used for "GS reset" and "Exit GS Mode." The "Universol non-
realtime message" format is used for "General fAIDI system on" and "General MIDI system off."
* General MIDI system on
This model wl be in on operational mode of "Patch Table 2" when receiving this message.
'Status Dotobyte Status
FOH 7EH, 7FH, OOH, O1W FH
Byte Description
FOH Exclusive status
TE 1D number (Universol Non-realtime Message)
TPH Device 1D (Broadcast)
09H Sub ID#1 (General MEDI Message}
OK Sub 1D#2 (General MIDI On)
FTH EOX (End Of Exclusive}
'When this message is received, Rx. BANK SELECT will be OFF ond Rx.NRPH will be OFF.
This message will not be received when "Exclusive" parameter of "IDI Rx Sw" group = OFF.
Moke an interval of SOms or more, before receiving the next message.
© General MIDI system off
This model will be in an operctional mode of "Patch Table 1 when receiving this message.
Status Dots byte Status
POH TEH, 7FH, O9H, O2H FR
Byte Description
FH Exclusive status
TE 1D number (Universal Non-realtime Message)
TF Device ID (Broadcast)
oH Sub {D#1 (General MID! Message)
02H Sub 1D#2 (General MIDI On}
FH FOX (End OF Exclusive)
This message will nat be received when "SysEx" porometer of "MID! Rx Sw" group = OFF.
'Make an interval of 5Oms or more, before receiving the nex! message.
© GS reset
This model will be in an operational mode of Patch Table 2" when receiving this massage.
Status Data byte Status
FOH 41H, dev, 42H, 12H, 40H, OOH, 7FH, OOH, 414 FH
Byte Description
FOH Exclusive stafus
ai 1B number (Roland)
dev Device 1D (dev: OOH — }FH (1 — 32), Initial volue is 10H (173)
42h Model ID (65)
1H Command 1D (DT1)
40H address MSB
OOH address
TF arldress LSB
OOH data (G5 rese!)
att Check sum
7H EOX (End Of Exclusive)