Download Print this page

Westinghouse MT25 ARM9 Installation And Assembly Manual page 3

Swivel wall arm for lcd screens

Advertisement

• When installing Peerless wall mounts on cinder block, verify that you have a minimum of 1-3/8" of actual concrete
surface in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid
part of the block, generally 1" minimum from the side of the block. Cinder block must meet ASTM C-90 specifica-
tions. It is suggested that a standard electric drill on slow setting is used to drill the hole instead of a hammer drill
to avoid breaking out the back of the hole when entering a void or cavity.
• Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.
• Make sure that the wall will safely support four times the combined load of the equipment and all attached hard-
ware and components.
For Concrete Walls drill one 1/4" (6 mm) dia. hole to a
minimum depth of 2" (51 mm). Insert anchor (E) in hole
flush with wall as shown (right). Place wall bracket, with
slot on tube facing down, over anchor (E) and secure
with #14 x 2" wood screw (D). Make sure wall bracket is
level, mark other hole and repeat steps with other
fasteners. Tighten all fasteners.
IMPORTANT: Make sure wall bracket is level on wall.
WARNING
• Tighten concrete anchor bolts firmly, but do not
overtighten. Overtightening can damage the bolts,
greatly reducing their holding power.
• Never tighten in excess of 80 in • lb (9 N.M.).
WARNING
• Concrete anchors are not intended for attachment to
concrete wall covered with a layer of plaster, drywall,
or other finishing material. If mounting to concrete wall
covered with plaster/drywall is unavoidable, plaster/
drywall (up to 5/8" thick) must be counterbored as
shown below. If plaster/drywall is thicker than 5/8",
custom fasteners must be supplied by installer.
Visit the Westinghouse Web Site at www.westinghousedigital.com
WARNING
1
Drill hole and insert anchor (E)
2
Place wall bracket over anchor (E) and secure with
screw (D)
3
After repeating step one tighten all fasteners
3 of 6
E
WALL
BRACKET
D
wall bracket
D
ISSUED: 04-16-04 SHEET #: 095-9194-1
For customer service call
concrete
wall
E
E
.
1-866-287-5555

Advertisement

loading