Advertisement
WORK
Removing the seat
3.1
Mounting the seat
3.2
Installing the start number plate
3.3
Installing the front wheel
3.4
Warning
Danger of accidents Reduced braking due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
–
Remove screw
above.
500080-10
–
Hook in the front of the seat at the collar sleeve of the fuel tank, lower it at the rear
and simultaneously push it forward.
–
Make sure that the seat is correctly locked in.
–
Mount and tighten the screw of the seat fixing.
Guideline
Remaining screws, chassis
500068-01
–
Position the start number plate. Mount and tighten screw
Guideline
Remaining screws, chassis
Info
Take care with the contact of the holding lug at the fender.
–
Position the brake line. Put the clamp on, and mount and tighten screw
500123-11
–
Clean and grease shaft seal rings
Long-life grease (
–
Insert the spacing sleeves.
500086-11
–
Lift the front wheel into the fork, position it, and insert the wheel spindle.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Operate the hand brake lever several times until the brake pads are lying correctly
on the brake disc.
–
Remove the motorcycle from the work stand.
500084-11
. Lift up the seat at the rear, pull it back and then remove from
M6
M6
and bearing surface
p. 11)
.
M24x1.5
5
10 Nm (7.4 lbf ft)
.
10 Nm (7.4 lbf ft)
.
of the spacing sleeves.
45 Nm
(33.2 lbf ft)
Advertisement
