Throttle Control And Choke Adjustments; Belt Adjustment; Belt Alignment - Scag Power Equipment STCII-61V-36BV Operator's Manual

R
- NOTE -
If after making the adjustment as outlined in step
2A, the machine creeps forward or backward,
perform the neutral adjustment. See Neutral
Adjustment.
TRACKING ADJUSTMENT
Figure 6-4. Tracking Adjustment
6.3 THROTTLE CONTROL AND CHOKE
ADJUSTMENTS
These adjustments must be performed by your Scag
dealer to ensure proper and efficient running of the engine.
Should either need adjustment, contact your authorized
Scag service center.

6.4 BELT ADJUSTMENT

WARNING
Before removing any guards, shut the engine off
and remove the ignition key.
All drive belts are spring loaded and self-tensioning,
however after the first 2, 4, 8 and 10 hours of operation,
the belts should be checked for proper alignment and wear.
Thereafter, check the belts after every 40 hours of operation
or weekly, whichever occurs first.
WARNING
If the pump drive belt fails, steering control will be
lost which could result in serious injury or death.
Replace the pump drive belt as needed or every
400 hours / 2 years, whichever occurs first.
BOLT

6.5 BELT ALIGNMENT

Belt alignment is important for proper performance of
your Scag mower. If you experience frequent belt wear or
breakage, see your Authorized Scag Power Equipment
service center for belt adjustment.
32
Section 6