–
Remove screws
–
Remove screws
–
Remove the license plate holder with the tail light.
Info
Pay attention to the cable of the tail light.
W00397-10
–
Loosen screws
fender.
–
Loosen screws
W00398-10
–
Position the turn signal on both sides on the license plate
holder, mount nuts
–
Position the license plate lamp on the license plate holder,
and mount and tighten screws
–
Connect the plug-in connections of the turn signals and
the license plate lamp with the wiring harness.
W00399-10
–
Drill a hole at marking
the size of the marking.
W00401-10
bl
.
bm
.
bn
and remove license plate holder from
bo
and hang the tail light to the side.
bp
with washers and tighten.
bq
.
A
on the license plate holder to
SETUP 2
11