Kenwood TS-670 Instruction Manual page 21

(3) Keyboard frequency entry
Frequency can be designated by operating the |ENT|
switch and the 10-key.
MEMORY
Ce a a a a
rc PGS
(4) Scan
4-1 [MS] (Memory Scan)
Memory scan in the TS-670 is performed on groups of 10
memory channels at a time. For example channels O thru 9
are considered to be one group, channels 10 thru 19 are
considered to be a group etc. The TS-670 can scan up to
20 channels (memory locations) at a time, so you must
specify which channels (up to two groups) you wish to
scan.
MEMORY
ah 228 oa all Oe
2G.s—4
PG.s___| {HOLD
MIN | [ENT
(1) Set the key to ON.
(2) The letter and two dots will be displayed.
(3) Press the keys corresponding to the frequency to be
selected.
(4) For entry to the nearest 10 Hz, press [2], [1], [2],
[3], [4], [5] and [6] keys. The frequency is
displayed to the nearest 100 Hz.
(5) Press the key.
NOTES:
1. If the frequency is entered to the nearest 10 Hz, it is
not necessary to press the [ENT] key.
2. It is not necessary to enter trailing zeros.
For example, 21.20000 MHz is entered as 21.2 MHz.
3. You must enter leading zeros. For example to enter
7 MHz press [0] . To enter 500 kHz
press [0] [0] [5] [ENT].
4. When recalling memory channel using the |VFO/M
switch, the channel number can be selected by using
the |ENT| switch, if the channel has data stored. If
the channel is vacant, the channel No. can not be set
using this method.
5. Frequencies outside of the operating range can not
be entered.
6. To display the frequency to the nearest 10 Hz see
page 27.
(1) Press and hold the {MS} key.
(2) Enter the first number of the two groups you wish to
scan.
For example: 10, and 40.
Press Oo) and [4] key.
NOTE:
To scan memory channels O — 9, simply press the
[Ms] key.
(3) Release the [MS] key.
(4) Scan will begin with the lowest channel.
(5) To stop scan press the key.
(6) To resume scan press the |HOLD] key again.
(7) To release memory scan press the [MS] key again.
(8) With the switch OFF, scan speed is approx.
2.5 seconds per channel.
With the switch ON, scan speed is approx.
1.4 seconds per channel.
NOTES:
1. Transmit is inhibited when the [HOLD] switch or the
[MS] switch is on.
2. During scan the band select relay will operate, as the
different bands are selected.
19