Sony SAT-A4 Operating Instructions Manual page 73

Step 2: Set the Remote Control's RF Security Code
1 Press the CODE SET button_on the remote control.
2 Using the number buttons on the remote control, enter the three-
digit security code you selected for the Digital Satellite Receiver in
step 2 on page 72.
3 Press the ENTER button on the remote control.
The RF security code is now changed for both the Digital Satellite
Receiver and remote control.
To Determine the Current
Security Code for the
Remote Control
(SAT-A4Only)
You can determine the current RF security code for the remote control
using the IDENTIFY button in the Set Up Remote screen.
1 Bring up the Set Up Remote screen, as described on page 71.
2 Select IDENTIFY.
SETUP REMOTE
REMOTE SIGNAL I IRONLY
RF SECURITY CODE [ 000
III]iliili"
I REMOTECOOES I
Press the joystick within 5 seconds.
3
When the message "Press the joystick within 5 seconds" appears,
press the joystick before the 5 seconds expire.
The current RF security code for the remote control appears.
SETUP REMOTE
I
REMOTE SIGNAL I IRONLY
I
nlb]:l_lll|_
RF SECURITY CODE 000
REMOTE CODES ]
Your remote is currently set at 000.
Note
If the message, "Security code could not be identiJied" appears, check to make
sure that RF is enabled and that the RF antenna is connected properly. See
"Selecting IR/RF Transmission (SAT-A4 Only)" on page 71.
4 Select OK to return to the Setup Menu.
73