Table of Contents
Advertisement
Alarm No.
E5
Overheat protection
E6
Motor lock
E7
Motor failure
E8
Switch failure
E9
Alarm for a long
period of use
-
Auto-stop with fas-
tening completion
-
Alarm for insufficient
fastening
-
Alarm for limit of the
fastening capacity
-
Maintenance alarm
-
Alarm for no com-
munication with
the PC
-
Indication that the
tool can communi-
cate with the PC
-
Check for the
lamp, indicator and
beeper (when the
battery cartridge is
installed)
Function
Status of the tool
Tool's controller
heated up abnor-
mally and the tool
stopped.
The motor has been
locked. At this time,
the tool does not
work.
The tool detected a
motor failure. At this
time, tool does not
work.
The tool detected a
switch failure.
The tool has been
turned on for a long
time (Approx. 3
minutes).
The preset fasten-
ing torque has been
achieved and the
tool has stopped.
The preset fas-
tening torque has
not been achieved
because the switch
trigger was released
before completing
the fastening.
The battery power is
almost used up.
The number of drive
has been reached to
your preset number
for the maintenance.
No data commu-
nication while the
tool is connected to
the PC.
The tool is con-
nected to the PC
and able to commu-
nicate with.
The tool performs
the operation test
for the LED indi-
cator (green/red),
lamp, indicator and
beeper.
Status of the LED indicator/beeper
LED indicator
Blinks in red quickly.
Blinks in red and
green alternatively.
Blinks in red and
green alternatively.
Blinks in red and
green alternatively.
Blinks in red and
green alternatively.
Lights up in green
for approximately
one second.
Lights up in red for
approximately one
second.
Blinks in red.
Blinks in yellow.
Blinks in yellow.
Blinks in green.
Lights up in green
and then red. After
that, the lamp turns
on for a while.
13 ENGLISH
Action to be taken
Beeper
A series of short
Remove the battery
beeps
cartridge immedi-
ately and cool the
tool down.
A series of short
Ask your local
beeps
Makita Service
Center for repair.
A series of short
Ask your local
beeps
Makita Service
Center for repair.
A series of short
Ask your local
beeps
Makita Service
Center for repair.
A long beep
Release the switch
trigger and pull it
again.
–
A long beep
Retighten the
fastener.
A series of long
Replace the battery
beeps
with fully charged
one.
–
Reset the alarm
with the application
software.
–
Restart the appli-
cation software and
re-connect the USB
cable.
–
A series of very
short beeps
–
–
–
Advertisement
Table of Contents
